The Record Info window gives information about header records in the data. This information is obtained from records received from the dispatcher or read from a ZDAB file.
This window can display information about the following types of records:
Here is a description of the displayed fields for the Run Record type:
Run Number is the number of the current run.
Start Time is the SHaRC start time for the run.
Run Type gives a list of the conditions for the run (see table below for a complete list of definitions).
Sources gives a list of sources deployed for the run.
Crate Mask lists the crates which were masked into the global trigger for the run.
Run Type Definitions
Neutrino standard neutrino run Source a source is deployed Calib calibration run NCD neutral current detector run Salt salt fill run Poison poison run Partial partial fill run Air air (no fill) run D2O D2O fill run H2O H2O fill run UC unusual circumstances during this run Trans transitional run -- detector configuration changing Src Moving source moving run Coils magnetic compensation coils are on ECA electronics calibration run Diag diagnostic run Supernova supernova run (trigger levels higher than standard neutrino run) Maint PMT hardware maintenance run PCA phototube calibration run Expt experimental run conditions D2O Circ the heavy water is circulating Bubbler the bubbler system is active SL Assay an SL assay is being performed NCD Maint NCD hardware maintenance run PMT Off the PMT system is not taking data NCD Off the NCD system is not taking data NCD ECA NCD electronics calibration run <##> unknown run type bit number ## is set